Rev FF
Released 2020 04-27
· Fixed grammatical error on TLA Step 1.
· Fixed incorrect hole quantity callout on Wing Frame Support parts.
· Updated Aluminum Tubes parts McMaster Carr part number - better quality part than the previous part number.
· Updated Stainless Steel Tubes parts McMaster Carr part number - better quality part than the previous part number.
· Modified Miscellaneous note in Tips+Tactics - do not tap wood for set screws.
· Added an image to Tips+Tactics that shows all parts in their starting orientations (for proper motion timing).
· Updated to Rev F standard:
    · Changed "The Fine Print" to "Terms of Use" .
    · Added "but not required" next to recommended tools.
    · Removed Letter to the Craftsperson page.
    · Moved Colibri sketch to the title page.
    · Removed Rev from file names and added Rev to the root folder.
    · Added a section in Tips+Tactics about tapping the metal tubes.
    · Updated Terms of Use.
    · Removed PDF layout of DXF files. DXF files now contain part names.
    · Plans now include STL files.

Rev CE
Released 2016 02-14
· Added a note to Miscellaneous Notes and to corresponding pattern page: To help increase longevity, make the Hypocycloid Cams from a hard material like brass, aluminum, or a durable plastic.

Rev CD
Released 2015 11-19
· Deleted extra page of Subassemblies 25, 26, and 27 - Forgot to delete this when updating the page in rev CC.
· Deleted Tail Mount Right from 3/8" DXF file - Forgot to delete this when it was copied to the 1/4" DXF file in rev CC.

Rev CC
Released 2015 11-01
· Re-exported all DXF files with polylines instead of spines to increase compatibility with older software.
· Fixed Wing geometry issue in 1/8" DXF file.
· Fixed Hummer Bill geometry issue in 3/8" DXF file.
· Tail Mount Right is a 1/4" part and was mislabeled as 3/8". Corrected error in:
    · Pattern pages
    · DXF files
    · DXF Layout PDF
    · All Parts + Assemblies List
· Fixed grammatical error in Gear Timing in Tips + Tactics (1st bullet point).
· Added a note for clarity in Subassemblies 25, 26, and 27.
· Added cross reference note between Subassembly 14 and Miscellaneous Notes in Tips + Tactics for clarity.
· Added note for clarity on Subassembly 22.
· Added a note in Tail Tuning in Tips + Tactics about screw sizing (2nd to last bullet point).

Rev CB
Released 2015 10-18
· Changed mislabeled hole on Counterweight Arm pattern from 5/32" to 9/32".
· Changed mislabeled hole on Hummer Bill Spacer from 1/14" to 1/4".
· Length of S Tube 1/4" x 25/32" was incorrect and was changed to S Tube 1/4" x 7/8". This change has been updated on the Parts + Assemblies list, the Metal Stainless Steel page, and on Subassembly Step 19.
· Added missing hole to Gear Large Spacer (back) parts 1/4" DXF file.
· Removed overlapping lines that were occurring in some 1/8" and 1/4" DXF file parts.

Rev CA
Released 2015 10-05
· Initial Release.